blast furnace gas boilers

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

blast furnace gas boilers have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


blast furnace gas boilers.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
blast furnace gas boilers blast furnace gas boilers blast furnace gas boilers

blast furnace gas steam boiler - albers-restaurant.

Coke oven gas and blast furnace gas boilers. 2019-2-14 · The coke oven gas and blast furnace gas boiler dust produced by ZG boiler have technical improvements to these characteristics, and finally the finished product is energy-saving and environmentally friendly. It is a thermal energy device that recycles economy and saves energy.

lexie@zozen.com > Get A Quote >

blast furnace | Sitong Wood Biomass Fired Boil

2019-3-17 · Blast furnace gas (BFG) is a by-product of blast furnaces that is generated when the iron ore is reduced with coke to metallic iron.It has a very low heating value, about 93 BTU/cubic foot (3.5 MJ/m 3), because it consists of about 60 percent nitrogen and 18-20% carbon dioxide, which are not flammable.The rest is mostly carbon

lexie@zozen.com > Get A Quote >

Blast Furnace Gas, its Characteristics and Safet

2019-6-17 · The blast furnace gas which comes out from the top of the blast furnace is at a high pressure (usually 1.5 atm to 2.5 atm in modern blast furnaces) and normally at a temperature of around 100 deg C to 150 deg C. When there are abnormalities in the burden descent then this temperature can be higher.

lexie@zozen.com > Get A Quote >

Blast Furnace / Coke Oven Gas Fired Boiler--Z

2019-4-26 · The coke oven gas/blast furnace gas boiler adopts "Π" type layout, front suspening back supporting, the plumping system, and superheater are suspended in the boiler roof, economizer and air preheater are set at the rear of steel frame, and the air preheater can be pulled out from the boiler rear, easy for maintenance and inspection.

lexie@zozen.com > Get A Quote >

Blast Furnace Gas Boiler Suppliers

2019-4-8 · This energy content can be utilized by recovering, cleaning, and storing the BF gas and using it as a fuel gas in the steel plant or in the boilers for the production of steam for the electricity generation. About blast furnace gas boiler suppliers, ZBG's blast furnace gas boiler is a good choice for you.

lexie@zozen.com > Get A Quote >

blast furnace gas fired hot water boiler 9 t

As a leader in industrial boiler manufacturers, ZBG offers 0.5-130 ton with pressure up to 9.81MPa / 98.1bar industrial gas and oil steam boilers, hot water boilers and power plant boilers. Flexible fuels: natural gas, heavy oil, light oil, coke oven gas, blast furnace gas, or dual fuel (burning gas and oil). Get a

lexie@zozen.com > Get A Quote >

Firing blast furnace gas without support fuel in stee

Request PDF on ResearchGate | On Jul 1, 2011, S.S. Hou and others published Firing blast furnace gas without support fuel in steel mill boilers

lexie@zozen.com > Get A Quote >

blast furnace gas fired hot water boiler 9 t

As a leader in industrial boiler manufacturers, ZBG offers 0.5-130 ton with pressure up to 9.81MPa / 98.1bar industrial gas and oil steam boilers, hot water boilers and power plant boilers. Flexible fuels: natural gas, heavy oil, light oil, coke oven gas, blast furnace gas, or dual fuel (burning gas and oil). Get a

lexie@zozen.com > Get A Quote >

blast furnace gas steam boiler - albers-restaurant.

Coke oven gas and blast furnace gas boilers. 2019-2-14 · The coke oven gas and blast furnace gas boiler dust produced by ZG boiler have technical improvements to these characteristics, and finally the finished product is energy-saving and environmentally friendly. It is a thermal energy device that recycles economy and saves energy.

lexie@zozen.com > Get A Quote >

30 Ton Gas Fired Steam Boiler India, Gas steam boile

2019-4-8 · Blast furnace gas from iron industry is reused and burned in steam boilers to generate steam and power for the industry. The 30 ton blast furnace gas steam boiler can also work as the driving force in co-generation or captive power plant. Many Indian companies or factories use the blast furnace gas boiler, resolving the flue gas emission as

lexie@zozen.com > Get A Quote >

Coke Gas or Blast Furnace Gas Boiler in Steel Industry

2019-4-26 · Coke Gas or Blast Furnace Gas Boiler in Steel Industry 2016-03-09 10:43:59. Steel industry consumes large energy every year and the high levels of power requirement and rising energy costs become a major challenge for the steel industry.

lexie@zozen.com > Get A Quote >