9301 combined heat

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

9301 combined heat have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


9301 combined heat.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
9301 combined heat 9301 combined heat 9301 combined heat

SELTEC - Our expertise is our streng

ANTICORIT DFW 9301 is stable against acidic or alkaline contamination and is therefore especially suitable for use in the galvanizing industry for conservation and drying. ANTICORIT DFW 9301 is suitable for inter-process, storage, and also as transport protection of components. It may be combined

lexie@zozen.com > Get A Quote >

9301 NE 23rd Ave, Vancouver, WA 986

For sale: beds 3, bath 2, 1326 sq. ft - 9301 NE 23rd Ave, Vancouver, WA 98665 $339800

lexie@zozen.com > Get A Quote >

9301 Old Oregon Inlet Rd, Nags Head, NC 279

For sale: beds 8, bath 7.5, 3800 sq. ft - 9301 Old Oregon Inlet Rd, Nags Head, NC 27959 $1095000

lexie@zozen.com > Get A Quote >

SELTEC - Our expertise is our streng

ANTICORIT DFW 9301 is stable against acidic or alkaline contamination and is therefore especially suitable for use in the galvanizing industry for conservation and drying. ANTICORIT DFW 9301 is suitable for inter-process, storage, and also as transport protection of components. It may be combined

lexie@zozen.com > Get A Quote >

9301 Old Oregon Inlet Rd, Nags Head, NC 279

For sale: beds 8, bath 7.5, 3800 sq. ft - 9301 Old Oregon Inlet Rd, Nags Head, NC 27959 $1095000

lexie@zozen.com > Get A Quote >

KEM

By KS C 9301 household electric fan (desktop or stand) which has the diameter of wing of 20~41 cm and the axial single wing run by induction motor to be used in general (table, stand, etc). 13: Air cleaner: By the scope of KS C 9314 the mechanical and combined air cleaner which has less 200W power consumption, and the single power 220V and 60Hz.

lexie@zozen.com > Get A Quote >

Special Issue 9303 - Protein and fat globul

Proceedings of the IDF Seminar held in Munich (DE) from 25-28 August 1992 The Proceedings are divided into six sections. Section 1 deals with the basic knowledge of milk components with regard to specific functional properties. The 10 papers in this section range from a study of the effect of heat on the membranes of []

lexie@zozen.com > Get A Quote >

Fire Detection Product Publicatio

2019-6-17 · 4009-9201, 4009-9202 CA, 4009-9301: 4009 IDNet NAC Extender for Control from 4010, 4010ES, 4100ES/4100U IDNet Communications, or Conventional NACs S4009-0003-10 : Electronic Heat Detectors for two-wire and four-wire bases, 135° F (57° C) or 200° F (93° C), available with or without rate-of-rise operation (D) (B) (C)

lexie@zozen.com > Get A Quote >

Energy efficiency improvement and GHG abatemen

1 According to the IAI statistics (), most of the fuel used in alumina refining is coal, gas and oil.Thus, for this analysis we set the share of biomass and waste on the overall fuel use to 0 %. 2 Due to non-reliable data concerning the fuel use in the non-ferrous metals industry in Russia, United Arab Emirates and South Africa, instead of the of the fuel mix breakdown in the non-ferrous

lexie@zozen.com > Get A Quote >

Role of autophagy in a model of obesity: A long‑ter

GRP78, additionally termed binding immunoglobulin protein, is a heat shock protein 70 molecular chaperone located in the lumen of the ER that binds newly synthesized proteins as they are translocated into the ER. When protein folding is disturbed inside the ER, GRP78 synthesis is increased .

lexie@zozen.com > Get A Quote >

Page A3 | e-Edition | azdailysun.c

1  · The Grand Canyon park is the biggest, and neediest, of the 23 national parks and monuments in Arizona that had a combined maintenance backlog of $507.5 million in fiscal 2018, according to

lexie@zozen.com > Get A Quote >