pulverized bituminous coal fired boiler

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

pulverized bituminous coal fired boiler have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


pulverized bituminous coal fired boiler.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
pulverized bituminous coal fired boiler pulverized bituminous coal fired boiler pulverized bituminous coal fired boiler

fired pulverized coal boilers - alibaba.c

Alibaba.com offers 98 fired pulverized coal boilers products. About 72% of these are boilers. A wide variety of fired pulverized coal boilers options are available to you, such as industrial, power station.

lexie@zozen.com > Get A Quote >

pulverized coal fired boilers - alibaba.c

Alibaba.com offers 95 pulverized coal fired boilers products. About 73% of these are boilers, 6% are energy saving equipment. A wide variety of pulverized coal fired boilers options are available to you, such as industrial, power station.

lexie@zozen.com > Get A Quote >

pulverized bituminous coal - microkelvin.

1 1 Bituminous And Subbituminous Coal Combustion. The most common heat transfer method for coal-fired boilers is the watertube method in which the hot combustion gases contact the outside of the heat transfer tubes while the boiler water and steam are contained within the tubes Coal-fired watertube boilers include pulverized coal cyclone stoker fluidized bed and handfed units

lexie@zozen.com > Get A Quote >

Pulverized Coal Fired Boilers - integratedglobal.c

Pulverized Coal Fired Boiler Waterwall Corrosion. PC-Fired Boilers generate thermal energy by burning pulverized coal that is blown by a combustion air stream to the burners in the firebox. These coal burners are typically located on the front and rear walls or in each of the corners to be known as wall fired or corner fired burners, respectively.

lexie@zozen.com > Get A Quote >

Pulverized Coal Fired Boilers - integratedglobal.c

Pulverized Coal Fired Boiler Waterwall Corrosion. PC-Fired Boilers generate thermal energy by burning pulverized coal that is blown by a combustion air stream to the burners in the firebox. These coal burners are typically located on the front and rear walls or in each of the corners to be known as wall fired or corner fired burners, respectively.

lexie@zozen.com > Get A Quote >

Pulverized Coal Fired Boilers - integratedglobal.c

Pulverized Coal Fired Boiler Waterwall Corrosion. PC-Fired Boilers generate thermal energy by burning pulverized coal that is blown by a combustion air stream to the burners in the firebox. These coal burners are typically located on the front and rear walls or in each of the corners to be known as wall fired or corner fired burners, respectively.

lexie@zozen.com > Get A Quote >

Firing a sub-bituminous coal in pulverized coal boiler

We verified the full-scale model predictions with results from a series of full-scale tests done with Adaro coal fired by IEC. For analysis of the operational parameters for firing Adaro coal in a boiler designed for bituminous coal combustion, we use EXPERT system, described by Chudnovsky et al. . This is an on-line supervision system which

lexie@zozen.com > Get A Quote >

Burning Fine and Pulverized Coal | Hand Fired Boiler

2013-11-3 · You can make bricks or pellets from it and then use it in either a hand-fired appliance or (pellets) stoker. If it's very low coke button coal, you can burn it in an underfeed stoker, but the high agglomerating coals will not burn at all in an underfeed stoker as fines. there's a reason why it's so cheap and the cost differential between that material and a sized, cleaned, uniform stoker or

lexie@zozen.com > Get A Quote >

coal furnace boiler – Coal Fired Boil

2018-2-2 · Low Pressure Coal fired steam boiler price,US $ 10,850 – 130,800 / Set, New, Natural Circulation, Industrial.Source from Henan Taiguo Boiler Co., Ltd. on Alibaba.com. 1 . coal-fired furnace coal-fired gas turbine coal-fired power plant coal-fired unit pulverized coal fired

lexie@zozen.com > Get A Quote >

Pulverised Coal - an overview | ScienceDirect Topi

Pulverized coal firing is the method of choice for large industrial boilers (e.g., > 250,000 lb steam/h) and coal-fired electric utility generators since pulverized coal-fired units can be constructed to very large sizes (i.e., up to ≈ 1300 MW or ≈ 9.5 million lb steam/h) and unlike stoker units, where some designs have coal

lexie@zozen.com > Get A Quote >

Pulverized coal-fired boiler - Wikiped

2019-5-24 · A pulverized coal-fired boiler is an industrial or utility boiler that generates thermal energy by burning pulverized coal (also known as powdered coal or coal dust since it is as fine as face powder in cosmetic makeup) that is blown into the firebox.. The basic idea of a firing system using pulverised fuel is to use the whole volume of the furnace for the combustion of solid fuels.

lexie@zozen.com > Get A Quote >