air lock in hot water system

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

air lock in hot water system have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


air lock in hot water system.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
air lock in hot water system air lock in hot water system air lock in hot water system

Removing an air lock in a water pipe | DIY Tips

Removing an air lock in a water pipe. Print Page Applying mains pressure to a pipe that is part of a building's stored water system presents a slight risk of water from the system seeping back into the mains water supply. disconnecting the hosepipe immediately after the airlock has been cleared. Clearing an air lock in a bathroom tap

lexie@zozen.com > Get A Quote >

How do you solve air lock in hot water system

most common cause is an air lock in the water system, several ways to eliminate:- drain the system and re-fill - with the system full run the engine to opperating temp with header tank/radiator

lexie@zozen.com > Get A Quote >

Removing an air lock in a water pipe | DIY Tips

Removing an air lock in a water pipe. Print Page Applying mains pressure to a pipe that is part of a building's stored water system presents a slight risk of water from the system seeping back into the mains water supply. disconnecting the hosepipe immediately after the airlock has been cleared. Clearing an air lock in a bathroom tap

lexie@zozen.com > Get A Quote >

Five minute DIY: Removing an air lock from your tap

2015-1-21 · Removing an air lock from your taps will help the flow of water through your home's water system while also relieving a headache or two for yourself. You might be wondering why your hot water

lexie@zozen.com > Get A Quote >

How do you remove an air-lock from a hot water pip

2006-8-29 · You don't have an Air lock, any air in the system will come out in a sputter, then flow- You have a problem with the Supply to the Water heater- both hot and cold should have the same pressure and only if the WH is not being supplied properly will you get the problem you mention.

lexie@zozen.com > Get A Quote >

How to get rid of an air lock in the plumbing syste

2006-9-18 · Best Answer: Every 6 months or so we get this problem and due to the air-lock we have no water sometimes coming through to cisterns or certain part of the house. WE have an old building and pipework everywhere. Cant afford to have them all replaced so we put up with the occasional airlock ourselves. We

lexie@zozen.com > Get A Quote >

How to get rid of an air lock in the plumbing syste

2006-9-18 · Best Answer: Every 6 months or so we get this problem and due to the air-lock we have no water sometimes coming through to cisterns or certain part of the house. WE have an old building and pipework everywhere. Cant afford to have them all replaced so we put up with the occasional airlock ourselves. We

lexie@zozen.com > Get A Quote >

How do I remove air from my system? - Solar Ho

First, be sure that your air purger is located on the high and hot side of your collector series. The hotter the fluid the less the ability for dissolved gasses to stay in solution and the higher the air vent, the more likely you will effectively remove trapped air that, due to its buoyancy, will rise to the top.

lexie@zozen.com > Get A Quote >

How To Quickly Fix a Hot Tub Air Lock

What Is a Hot Tub Air Lock? Before you can begin to fix an air lock in a hot tub, you need to understand what it is. In most cases, an air lock occurs when you drain your hot tub, clean it and then refill it. During that time that your hot tub sits without water, air can become trapped inside your hot tub.

lexie@zozen.com > Get A Quote >

Combi systemairlock driving me mad! | Screwfi

2006-4-17 · Combi systemairlock driving me mad! Discussion in 'Plumbers' Talk' started by When I'm running hot water the boiler goes on and off intermitently so I am not getting a constant supply of hot water. Now turn on the heating, you may have an air lock inside the boiler that the pump cannot push out. the 3 bar will help, reduce pressure

lexie@zozen.com > Get A Quote >

Hot Water Airlock Problems Solved In 15 Different Wa

Hot Water Airlock Problem & Cures. If you have an hot water airlock problem but no way to understand on how this happened or how to get an airlock out of the hot water system then carry on reading below as Martin an experienced emergency plumber in Manchester explains all the cures. Just below we explain the most asked questions the further below we answer all the questions that people are

lexie@zozen.com > Get A Quote >